Gemvara

October 2017
M T W T F S S
« Aug    
 1
2345678
9101112131415
16171819202122
23242526272829
3031  

How to Use a Hammer Drill

A hammer drill is used to drill inside of concrete, brick or some other type of masonry material. This particular piece of equipment works by delivering rapid blows into a masonry object. People use them to fasten objects onto bricks and into concrete. This powerful tool comes in variety of different sizes but we will focus on the hand held models that can be used around the home. The following material will explain how to use a hammer drill to get the best results for your project using hammer drill comparison.

Safety is Important

When you decide to use a hammer drill you should at least wear a pair of safety goggles or glasses. This will protect your eyes from shrapnel. You should also wear gloves on your hands to protect them from nicks, cuts, scrapes and heat.

Setting up your Work Area and Using your Drill

Hammer DrillRead the manufacturer’s instruction to know how to properly use your drill. Once you read the instructions the next step is to plan out your work. Planning helps to save time and effort when carrying out a project. Next, you must set up the area that is going to be drill. If you are planning on drilling a single object, put it into the designated area where you will need to drill.

Keep in mind that concrete and brick is heavier than wood. So, it might not be practical to move a chunk of concrete to a work table. So, you must make adjustments with a hammer drill and go to the place where you want to complete your project and learn more from here.

Using the Drill

Find the right size drill bit that you will need for the job. Place the bit into the chuck and prepare for the job. Remember that smaller hand held hammer drills are for small jobs requiring you to fasten objects into place on a brick wall or onto concrete. Make sure you know where you want to drill. Then you should start to drill in that area.

When you begin to drill, keep the unit strait and steady. Allow the drill to do the work. You should not push down forcefully on the unit to make a hole. Instead, just apply enough pressure to assist the drilling process. As you drill, stop about half way through the job. Take the drill out of the hole. This will allow you to get rid of any dust that will accumulate from the drilling process. Once you get rid of the dust, finish drilling the hole. Hammer drills are not complicated to use but it will require practice to learn how to use one like a pro.

Comments are closed.